LawGrids logoLAWGRIDS.ORG

Rule 96, THE CENTRAL MOTOR VEHICLES RULES, 19891: Brakes

THE CENTRAL MOTOR VEHICLES RULES, 19891 - Rule 96

Text of rule 96

Brakes

96. Brakes.—162[(1) Every motor vehicle, other than a motor cycle, three-wheeled invalid carriage, trailer or a road roller shall be equipped with two independent and efficient braking systems, namely, the parking brake and foot operated service brake: Provided that a motor cycle and three-wheeled invalid carriage shall be equipped with the independent and efficient braking systems, either both hand operated or one foot operated and the other hand operated.] (2) The braking system shall be of strength capable of stopping the vehicle within the distance specified in sub-rule (8) and of holding it at rest in all conditions and all such brakes at all time be properly connected and maintained in efficient condition. 163[***] (3) In every motor vehicle 164[other than agricultural tractors,] the brakes operated by one of the means of operation shall act directly upon the wheel and not through the transmission gear. 165[(4) Every motor vehicle manufactured on and after the 1 st day of April, 2006 shall have a braking system whose performance shall conform to the following Indian Standard, namely:— (i) for two-wheelers and three-wheelers IS:14664:1999, as amended from time to time. Table. 162 Substituted by G.S.R. 338(E), dated 26-3-1993 (w.e.f. 26-3-1993). 163 Proviso omitted by G.S.R. 338(E), dated 26-3-1993 (w.e.f. 26-3-1993). 164 Added by G.S.R. 338(E), dated 26-3-1993 (w.e.f. 26-3-1993). 165 Sub-R. (4) substituted by G.S.R. 589(E), dated 16-9-2005 (w.e.f. 16-9-2005). SI. No Type of vehicle Load Test speed (The speed at which the brake should be applied) (Kmph) Type of brake Stopping distance (m) 1. All vehicles other than Laden to the 30 Fool operated 13 motor cycles, three- wheelers and agricultural tractors registered GVW or Unladen 30 service 13 Do Laden or 40 do 21 Do Unladen 40 do 21 2. Motorcycles Unladen 30 Foot or hand operated 21 3. Three-wheelers including three-wheeler tractors for trailer Unladen 30 Foot operated (brakes operational: on at least two wheels) 13 Kg 4. Agricultural tractors Laden to test mass 25 Foot operated service 10 77 5. All other than three- wheelers of engine capacity not exceeding 500 cc, motor cycles and agricultural tractors Laden to the registered GVW or Unladen 30 40 30 40 -do­ -do­ -do­ -do- 12.7 15.0 9.3 12.0 For the purpose of this test for vehicles other than motor cyc es the "unladen" means the vehicle is without any load and shall carry only the driver and another person for specific purpose of supervising the test, and the instruments, if any. In the case of motor cycles, the "unladen" means that vehicle will carry only the single rider and the measuring instrument, if any.] 166[(9) The following category of vehicles shall be fitted with Anti-Lock Braking System conforming to IS:11852:2003 (Part 9):— (0 N2 and N3 category of vehicles other than tractor-trailer combination manufactured on and after the 1st day of October, 2006 meant for carrying hazardous goods and liquid petroleum gas; (ii) N3 category vehicles manufactured on and after the 1st day of October 2007, which are double decked transport vehicles; (iii) N3 category vehicles manufactured on and after the 1st day of October 2007, that are used as tractor-trailer combinations. (iv) M3 category of buses that ply on All India Tourist permit, manufactured on and after the 1st day of October, 2007.] 167[96-A. Brakes for construction equipment vehicle.—(1) Construction equipment vehicle with hydrostatic transmission shall employ either hand or foot operated hydrostatic braking system both for service and parking brake system acting at least on two wheels on the same axle or drum. (2) The braking system shall be of a strength capable of stopping the vehicle within the distance specified in sub-rule (8) and of holding it at rest in all conditions, and all such brakes shall at all times be properly conducted and maintained in efficient condition. (3) In every construction equipment vehicle, other than those having hydrostatic transmission, the brakes operated by any of the means of operation shall act directly upon the wheel or at a suitable location in the power train provided that such an action does not discouple, disengage or isolate- the braking action from the wheels. (4) Every construction equipment vehicle which manufactured on or after the commencement of the Motor Vehicles (Sixth Amendment) Rules, 2000, shall have a 166 Sub-R. (9) inserted by G.S.R. 589(E), dated 16-9-2005 (w.e.f. 16-9-2005). 167 Inserted by G.S.R. 642(E), dated 28-7-2000 (w.e.f. 28-7-2000). 78 braking system whose performance shall A[conform to the test and stopping distance formula as specified in sub-rule (7)]. (5) The braking system or one of the braking systems of construction equipment vehicle, shall be so constructed and maintained that it can effectively prevent at least two wheels or drums from revolving when the vehicle is left unattended and it shall be designed to be applied through hand or foot or automatically when engine is not running. (6) In the case of construction equipment vehicles with four or more than four wheels, the service brake shall work on at least two wheels of the vehicle. 168[(7)The service braking system of the construction equipment vehicle shall be capable of bringing the vehicle to a halt within the stopping distance as calculated by the formula given below, when tested in unladen condition and attachment carry position at a speed corresponding to 80 per cent, of the design maximum speed. The test shall be conducted in the forward direction of travel on a dry level hard road in good condition and during the test the acceleration control or travel shall be fully released and in the case of vehicle with manual gear shifting control, the top gear and the clutch shall be engaged.] STOPPING DISTANCE FORMULA S < 0.15v + (V2/130), Where S is the Stopping distance in metres, V is the test speed corresponding to 80% of design maximum speed in Km / h., Control force F < 700 Newtons. Explanation.—For the purposes of this sub-rule, "unladen" means the construction equipment vehicle in travel mode without any load except the driver and another person for the specific purpose of supervising the test and the instruments, if any: Provided that while the stopping distance formula mentioned above remain unchanged, the construction equipment using hydrostatic transmission, the brake test shall be performed by positioning the gear change lever to the neutral position.] 169[ 168 169 170[96-B. High Speed Braking Requirements].—For high speed braking, the following test procedure shall be followed, namely:— 168 Substituted by G.S.R. 116(E), dated 27-2-2002 (w.e.f. 27-8-2002). 169 Inserted by G.S.R. 400(E) dated 31-5-2002 (w.e.f. 31-5-2002). 170 Substituted by G.S.R. 720(E), dated 10-9-2003, for the figures, letter and words "96-A High Speed Braking Requirements" (w.e.f. 10-10-2003). 79 (a) in the case of Category M-l, the P type, service brake test as defined under IS: 11852-2001—Part 3, shall be carried out in the engine connected mode at a test speed of 120 km/h or at 80% of the design maximum speed of the vehicle, whichever is lower. (b) the stopping distance requirements shall be according to the following formula, namely:— S < 0.1 V + (V2/130): where, S is the Stopping Distance in mtrs. V is the test speed in km/h, and Control force F< 500 Newtons. Provided that this sub-rule shall be applicable in case of new vehicles yet to be type approved after six months, and in case of already type approved vehicles, twelve months, from the date of the commencement of the Central Motor Vehicles (Third Amendment) Rules, 2002.] 171[96-C Brakes for agricultural tractor.—The braking system of the agricultural tractor shall conform to IS: 12061-1994 and IS: 12207-1999, as amended from time to time.] 172[96-D. Braking requirements for power tillers.—The power tillers when coupled to a trailer shall meet the following requirements, namely:— (i) the brake test for the power tiller coupled to a trailer shall be carried out with a gross combination weight not exceeding 1.5 tons as declared by the manufacturer; (ii) The brake test shall be conducted at a speed of 15 km/h to meet the stopping distance requirement of 7.5 metres with the pedal effort not exceeding 600N; (iii) The trailer coupled to the power tiller shall be fitted with a parking brake capable of holding the combination on an up-slope and down-slope gradient of 12%.]

Previous and next

All provisions of THE CENTRAL MOTOR VEHICLES RULES, 19891

Questions people ask

Is rule 96 of THE CENTRAL MOTOR VEHICLES RULES, 19891 still in force?

No repeal of the CENTRAL MOTOR VEHICLES RULES, 19891 is recorded.