Form II, THE INDIAN ELECTRICITY RULES, 1956: FORM II
THE INDIAN ELECTRICITY RULES, 1956 - Form II
Text of form II
FORM II
FORM II
INSPECTION REPORT
(Under rule 46 of the Indian Electricity Rules, 1956)
(Medium voltage installations of a consumer)
Report No…………….. Date of Inspection……………
Challan No……………. Dated……………………….
Inspection Fee Rs……... Date of Last inspection…………….
1. Consumer No
2. Voltage and system of supply:
(i) Volts…………………………
(ii) No. of phases…………………..
(iii) AC/DC………………………..
3. Name of the consumer/owner…………….
4. Address of the consumer/owner………….
5. Location of the premises………………….
6. Particulars of the Installation:
I. Motors:
Make No. H.P Amps. Voltage
(1)………………………
(2)………………………
(3)……………………...
(4)………………………
(5)……………………...
II. Other equipment (complete details to be furnished):
(1)……………………….
(2)……………………….
(3)………………………..
Total connected load h.p/k va……………………
III. Generators (in the case of consumer himself generating energy):
(1)………………………..
(2)………………………..
(3)………………………..
7. General condition of the installation:
Rule of the Indian
Electricity Rules, 1956
Requirements Reports
1 2 3
3. Is the list of authorised persons properly made and kept up to date duly
attested?
29. (i) Is/Are there any sign(s) of over loading?
(ii) State if any unauthorised temporary installation exist.
(iii) Are the electric supply lines and apparatus so installed, protected, worked
and maintained as to prevent danger?
(iv) Any other general remarks.
30. Service line and apparatus of the supplier on consumer’s premises.
Give report on condition of service lines, cables, wires and apparatus and such
other fittings placed by the supplier/owner on the premises.
31. Has the supplier provided suitable cut-outs within consumer’s premises, in
an accessible position? Are they contained within an adequately enclosed fire
proof receptacle?
32. (i) State if switches are provided on live conductors.
(ii) State if indication of a permanent nature is provided as per this rule so as
to distinguish neutral conductor from live conductor.
(iii) Whether a direct link is provided on the neutral in the case of single phase
double pole iron-clad switches instead of fuse?
33. (i) State if earthed terminal is provided by the supplier.
(ii) Is the Consumer’s separate earth efficient?
(iii) Report on the efficiency of the earthing arrangement.
34. (i) Are bare conductors in building inaccessible?
(ii) Whether readily accessible switches have been provided for rendering
them dead?
(iii) Whether any other safety measures are considered necessary?
35. State if “Danger Notice” in Hindi and the local language of the district and
the type approved by the Electrical Inspector is affixed permanently in
conspicuous position as per this rule.
38. State if flexible cables used for portable or transportable equipment
covered under this rule, are heavily insulated and adequately protected from
mechanical injury.
44. (i) State if instructions in 1[English or Hindi and the local language of the
district
and where Hindi is the local language, in English and Hindi,] for the restoration of
persons suffering from electric shock have been affixed in a “conspicuous place.”
(ii) Are the authorised persons able to apply instructions for resuscitation of
persons suffering from electric shock?
49. Leakage on premises:,
State insulation resistance between conductors and earth in Megaohms.
50.(i) Whether a suitable linked switch/circuit breaker is placed near the point of
commencement of supply so as to be readily accessible and capable of being
easily operated to completely isolate the supply?
(ii) Whether every distinct circuit is protected against excess energy by
means of a suitable circuit breaker or cut-out?
(iii) State if a suitable linked switch or circuit breaker is provided near each
motor or apparatus for controlling supply to the motor or apparatus.
(iv) State if adequate precautions are taken to ensure that no live parts are so
exposed as to cause danger.
51. (i) State the condition of metallic coverings provided for various conductors.
(ii) (a) State whether clear space of 90 cm is provided in front of the main
switch board.
(b) State whether the space behind the switch board exceeds 75 cm in width
or is less than 23 cm.
(c) In case the clear space behind the switch-board exceeds 75 cm. state
whether a passage way from either end of the switch-board to a height of 1.80
metres is provided.
61. (i) Has the neutral conductor at the transformer been earthed by two
separate and distinct connections with earth.
(ii) Have the frame of every generator, stationary motor and so far as
practicable portable motor and the metallic parts (not intended as conductors) of
all transformers and any other apparatus used for regulating or controlling energy
and all medium voltage energy consuming apparatus been earthed by two
separate and distinct connections with earth?
(iii) Have the metal casings or metallic coverings containing or protecting any
electric supply line or apparatus been properly earthed and so joined and
connected across all junction boxes as to make good mechanical and electrical
connection’
(iv) State if the consumer’s earth electrode is properly executed and has been
tested with satisfactory results.
(v) Is the earth wire free from any mechanical damage?
Overhead Lines:
74. (i) State if the consumer has any overhead lines and if so their condition to
with specific reference to relevant rules.
93. (ii) Is there any other overhead line near the premises of the consumer
which does not comply with rule 79 or 80?
(iii) Is guarding provided for overhead lines if it is inside the factory, for road
crossings and busy localities?
(iv) Any other remarks.
Inspecting Officer’s Signature
Name:………………..
Designation:………….
File No……………..
Dated: ……………….
1. Ins. by Notification No. G.S.R. 735, dated 4th September, 1982.
Previous and next
Questions people ask
Is form II of THE INDIAN ELECTRICITY RULES, 1956 still in force?
No repeal of the INDIAN ELECTRICITY RULES, 1956 is recorded.