Rule 57, Rajasthan Factories Rules,1951: Exemption of certain hoists and lifts
Rajasthan Factories Rules,1951 - Rule 57
Text of rule 57
Exemption of certain hoists and lifts
57.Exemption of certain hoists and lifts. — (1) A register shall be opened with the
following columns to record particulars of examination of hoists and lifts:—
(1) Date of examination.
(2) No. of hoists and lifts, if more than one.
(3) The details of tests made.
(4) Results of examination.
(5) Signature of examiner.
(6) Designation and qualification of the examiner.
(2) In pursuance of the provision of sub-section (4) of section 28, in respect of any class or
description of hoist or lift specified in the first column of the following Schedule, the
requirements of the section 28 specified in the second column of the said Schedule and set
opposite to that class or description of hoist or lift shall not apply.
Schedule
Class or description of hoists or lift Requirements which shall not apply
Hoists or lifts mainly used for raising
materials for charging blast furnaces
or lime kilns.
Sub-section (1)(b) in so far4 as it
requires a gate at the bottom landing
sub-section (1)(d); sub-section
(1)(e).
Hoists not connected with
mechanical power and which are not
used for carrying persons.
Sub-section (1)(b) in so for as it
requires the hoist way or lift way
enclosure to be so constructed, as to
prevent any person or thing from
being trapped between any part of
the hoist or lift and any fixed
structure or moving part; sub section
(1)(e).
@[57A. - (1) No. lifting machine and no chain. rope or lifting tackle, except a fiber rope or
fiber rope sling, shall be taken in use in any factory for the first time in that factory unless it
has been tested, and all parts have been thoroughly examined by a competent person and
a certificate of such test and examination specifying the safe working load or loads and
signed by the person making the test and the examination, has been obtained and is
available for inspection.
(2) (a) Every jib-crane so constructed that the safe working load may be varied by the
raising or lowering of the jib, shall have attached thereto either an automatic indicator of
safe working loads, or an automatic jib, angle indicator and a table indicating the safe
working loads at corresponding inclination of the jib or corresponding radii of the load.
(b) A table showing the same working load of every kind and size of chain. rope or lifting
tackle in use, and in the case of multiple sling, the safe working loads at different
angles of the legs, shall be posted in the store room or place where or in which the
chains, ropes of lifting tackles are kept, and prominent positions on the premises and
no rope, chain or lifting tackle not shown in the table shall be used.
The foregoing provisions of this paragraph shall not apply in respect of such lifting tackle, if
the safe working load thereof, or in the case of a multiple sling, the safe working load at
different angles of the legs, is plainly marked upon it.
-----------------------------------------------------------------------------------------------------------------------
@. Added vide Notification No. F. 3(56) Lab/3. dated 21.9.1965; published in Rajasthan
Gazette Part IV-Ga dated 11.11.65.
(3) Register to be maintained under sub-clause (iii) of clause (a) of sub-section (1) of
section 29 of the Act, shall contain the following particulars—
(i) name of occupier of factory,
(ii) address of the factory,
(iii) distinguishing number of mark, if any, and description sufficient to identify the lifting
machine, chain, rope or the lifting tackle,
(iv) date when the lifting machine, chain, rope or lifting tackle was first taken in use in
the factory,
(v) date and number of the certificates relating to any test or examination made under
sub-rules (1) and (7) together with the name and address of the person who issued
the certificates,
(vi) date of each periodical thorough examination made under clause (a)(iii) of sub-
section (1) of section 29 of the Act and sub-rule (6) and by whom it was carried out.
(vii) date of annealing or other heat treatment of the chain and other lifting tackle made
under sub-rule (6) and by whom it was carried out, and
(viii) particulars of any defects affecting the safe working load found at any such
examination or after annealing and of the steps taken to remedy such defects.
The register shall be kept readily available for inspection.
(4) All rails on which a travelling crane moves and every track on which the carriage of a
transporter or runway moves, shall be of proper size and adequate strength and have an
even running surface and every such rail or track shall be properly laid, adequately
supported and properly maintained.
(5) To provide access to rail tracks or over head travelling cranes, suitable passage ways,
of at least 50 cm. (20 inches) width with toe-boards and double hand rails 90 cm. (3 ft.)
high, shall be provided alongside, and clear of the rail tracts of over head travelling @[Floor
operated cranes where rail height is more than #[24 feet] or all cabin operated travelling]
cranes, such that no moving part of the crane can strike persons on the ways and the
passage way shall be at a lower level than the crane track itself. Safe access ladders shall
be provided at suitable intervals to afford access to these passage ways and from passage
ways to the rail tracks.
(6) All chains and lifting tackle, except a rope sling shall, unless they have subjected to such
other heat treatment, as may be approved by Chief Inspector of Factories be effectively
annealed under the supervision of a competent person at the following intervals:—
(i) all chains, slings, rings, hooks, shackles, swivels used in connection with molten
metal or molten slag or when they are made of I /2inch bar or smaller, once at least in
every six months,
(ii) all other chains, rings, hooks, shackles and swivels in general use, once at least in
every twelve months:
Provided that chains and lifting tackle not in frequent use, shall subject to the Chief
Inspector's approval, be annealed only when necessary. Particulars of such annealing shall
be entered in a register prescribed under sub-rule (3).
------------------------------------------------------------------------------------------------------------------------
@. Inserted vide Notification No F12(9)L&E/83 dated 25.2.1985; published in Rajasthan
Gazette Extraordinary Part IV-Ga. dated 27.2.85.
#. Substituted vide Notification No. F.4(3) Shram/88 dated 8.1.1991, published in
Rajasthan Gazette Part 3(Ga) dated Rajasthan 25.6.1992
(7) Nothing in the foregoing sub-rule (6), shall apply to the following classes of chains and
lifting tackles -
(i) chain made of malleable cast iron,
(ii) plate link chains,
(iii) chains, rings, hooks, shackles and swivels made of steel or of any non-ferrous
metal,
(iv) pitched chains, working on sprocket or packeted wheels,
(v) rings, hooks, shackles and swivels permanently attached to pitched chains, pulley
blocks of weighing machines,
(vi) hooks and swivels having screw threaded parts or ball-bearing or other case
hardened parts,
(vii) socket, shackles secured to wire ropes by white metal capping, and
(viii) Bordeaux connections.
Such chains and lifting tackles shall be thoroughly examined by competent person, once at
least in every twelve months, and particulars entered in the register kept in accordance with
sub- rule (3).
(8) All lifting machines, chain, ropes and lifting tackle, except a fiber rope or fiber rope sling
which have been lengthened, altered or repaired by welding or otherwise, shall before being
again taken in use, be adequately re-tested and re-examined by a competent person and a
certificate of such test and examination be obtained and particulars entered into register
kept in accordance with sub-rule (3).
(9) No person under 18 years of age and no person who is not sufficiently trained in the
working of lifting machines and acquainted with the hazards of the machine, shall be
employed as driver of a lifting machine, whether driven by mechanical power or otherwise,
or to give signal to a driver.
(10) Where, in the opinion of the State Government, compliance with any of the requirement
of the provisions contained in section 29 of the rules made thereunder, is unnecessary or
impracticable, the State Government may, by notification in the Official Gazette, and subject
to such conditions, as it may deem expedient, exempt any factory or a group or class or
description of factories from any such provision.]
Pressure Plant
Rules prescribed under sub-section (2) of section 31.
Previous and next
Questions people ask
Is rule 57 of Rajasthan Factories Rules,1951 still in force?
No repeal of Rajasthan Factories Rules,1951 is recorded.