LawGrids logoLAWGRIDS.ORG

Rule 7, The Punjab Distillery Rules, 1932: Freedom from water

The Punjab Distillery Rules, 1932 - Rule 7

Text of rule 7

Freedom from water

7. Freedom from water. - Light caoutchoucine should not contain any appreciable amount of water. Any officer engaged in drawing samples for test should certify on the bottle that he has drawn the samples from the bottom of the containing vessel where the water, if present, will be found. For this purpose he should employ a siphon tube of which the shorter limb reaches to the floor of the containing vessel. He should also assure himself that the sample is collected in a bottle free from moisture. (b) Specification for Mineral Pyridine Bases I. Colour. - The colour must not be darker than that given by two cubic centimetres of deci-normal iodine solution dissolved in one litre of distilled water. II. Miscibility with water. - 20 c.c. of the pyridine bases should give a clear mixture with 40 c.c. of water, or else a mixture only so slightly opalescent that, after standing for five minutes, ordinary newspaper type is clearly visible through a layer 15 cm. deep. III. Amount of water present. - From 20 c.c. of the pyridine bases mixed with 20 c.c. of caustic soda solution density (1.4) at least 18.5 c.c. of the bases should separate after having been repeatedly shaken together and allowed to stand. IV. Titration. - Dissolve 1 c.c. of the pyridine bases in 10 c.c. of distilled water. Titrate with normal sulphuric acid until a drop of the mixture gives a definite blue spot on congo-red paper (the blue colour should at once disappear). At least 10 c.c. of the normal sulphuric acid should be required to produce this reaction (To prepare the congo-red paper, dissolve one gram of congo-red in one litre of distilled water. Soak filter paper in this and then dry.) V. Cadmium Chloride reaction. - Vigorously shake together 10 c.c. of a solution of 1 c.c. of pyridine bases in 100 c.c. of distilled water with 5 c.c. of a 5 per cent, solution of dry fused Cadmium Chloride. A distinct crystaline precipitate should immediately result. Boiling point. - Distil 100 c.c. of the pyridine basis in the manner described below. At least 90 per cent, should distil over, at or under 140 degree C. Method. - 100 c.c. of pyridine bases are placed in a short-necked copper flask of about 200 c.c. capacity. The flask is arranged on an asbestos card, which has a circular hole of 30 m.m. diameter out in it. To the flask is attached a fractionating column (consisting of a tube 13 m.m. wide and 170 m.m. long, provided with one bulb) of which the side tube (issuing 1 c.m. above the bulb) joins a Liebig's condenser of which the cooled part is at least 400 m.m. long. A standard thermometer is placed in the head of the column so that this bulb occupies the centre of the bulb of the column. The speed of distillation is adjusted to 5 c.c. per minute, the distillate being received in a graduated glass cylinder. At least 90 c.c. should distil over, at, or under, 140 degrees C. at a barometric pressure of 760 m.m. If the barometer varies from 760 m.m. a correction of 1 degree C. for each 30 m.m. of variation should be applied (e.g. under 770 m.m. of pressure 90 c.c. of distillate should come over at or under 140.3 degrees C. whilst under 750 m.m. the same amount of distillate should come over at 139.7 degree C.) (c) Specification of Crude Wood Naphtha 1. Not more than 30 cubic centimetres of wood naphtha should be required to decolourise 0.5 grams of bromine. 2. It should be neutral or slightly alkaline to litmus; 25 cubic centimetres of wood naphtha should require at least 5 cubic centimetres of N/10 acid using methyl orange as indicator. 3. It must contain at least 72 per cent by volume of methyl alcohol (Methanol). In order to estimate the amount of methanol the fractional distillation test (Government Laboratory, London) will be taken as standard. 4. In 100 cubic centimetres of wood naphtha there should not be less than 5 grams of substances present (calculated as acetone) as measured by Messinger's test. 5. There should be not less than 1.5 grams of esters present calculated as methyl acetate. The fractional distillation test is as follows :- 100 cubic centimetres of the sample are to be slowly heated in a small copper flask fitted with a glass fractionating column 175.28 millimetres (7 inches) high and 19.05 millimetres (3/4 inches) in diameter filled to the extent of 100.16 millimetres (4 inches) of its height with small glass beads provided with a thermometer place opposite the exit tube about 25.4 millimetres (as inch) above the beads and then connected with a spiral condense. Not more than 10 cubic centimetres of distillate should be collected in the receiver when the thermometer in the fractionating column marks a temperature of just under 149 degree F. (65 degree C.) from 80 cubic centimetres to 84 cubic centimetres should pass over between 149 F. (65 C) and 162 degree F. (72.2 degree C), and a total quantity of 97 cubic centimetres to 98 cubic centimetres should have passed over before the thermometer marks 212 degree F. (100 C).

Previous and next

All provisions of The Punjab Distillery Rules, 1932

Questions people ask

Is rule 7 of the Punjab Distillery Rules, 1932 still in force?

No repeal of the Punjab Distillery Rules, 1932 is recorded.