Rule 20, Bangalore Metro Railway (General) Rules, 2011: Control of Signaling
Bangalore Metro Railway (General) Rules, 2011 - Rule 20
Text of rule 20
Control of Signaling
20. Control of Signaling.- (1) (i} Main line signaling is controlled from an Operations Control
Centre and operates normally under automatic control with routes being set and train
intervals regulated by computer control;
(ii) the Traffic Controller shall be responsible for maintaining the services at the scheduled
level as far as practicable and for restoring the train services following a delay or
disruption;
(iii) the Traffic Controller at the Operations Control Centre may adjust the timetable and
may intervene manually to set and clear routes if the timetable needs to be varied or in
the event of a major disruption;
(iv) normally signaling system shall permit only one train at a time in one Tunnel
Ventilation Section, more than one train in one Tunnel Ventilation section can be sent
only in case of emergencies, and in a case the Traffic Controller decides to send
additional trains in a Tunnel Ventilation section already occupied by a train, he shall
set the route manually for additional trains and shall advise train operators about this
before authorizing them to proceed;
(v} the Traffic Controller, if required, may hand over control of the signals at specific
station to the Station Controller and a local control panel or work-station shall be
provided in the station control room for this purpose;
(vi) the handover takes place automatically if there is a loss of control of individual
stations from Operations Control Centre;
(vii) in case of complete failure of control from Operations Control Centre, the entire control
may be transferred to a backup control centre at an alternate location, which may be
at separate locations for traffic control and control of traction power;
(viii) the Traffic Controller shall have control of all routes on the main line outside of depots.
(ix) train movement shall normally be under computer control but the Traffic Controller has
the capability of setting routes manually and of setting individual points, if necessary.
(2) Safety Communication-
(i) all communication between Operations Control Center and train operators, Station
Controller, maintenance staff of electrical, rolling stock, signal and telecommunication
and track and structures department and others pertaining to movement of trains shall
be tape-recorded and preserved for 'incident, analysis and, training, and the mode of
preservations and its duration shall be specified in special instructions;
(ii) the employee of the Bangalore Metro Railway shall initiate and acknowledge radio
messages in a manner that ensures establishment of communication only between
intended parties;
(iii) messages affecting train movements shall be addressed by the Traffic Controller to
only one train at a time:
[ 'lT'T Il-"lll"6 3(i)] 17
Provided that in an emergency, a blanket message may be sent by the Traffic
Controller to all trains in or approaching a particular area, which must be
acknowledged individually by all concerned train operators:
Provided further that in an emergency, such message may be given by the Station
Controller, if authorised by the Traffic Controller in this behalf.
(3) Running Lines-
(i) the Signaling system on the running line shall be a full Automatic Train Protection
system;
(ii) if the speed which permits a train running on Automatic Train Protection to stop under
normal braking within a limit of safety, is exceeded, an irrevocable emergency brake
application is automatically made which ensures that the train does not proceed
beyond the safe limit;
(iii) normal operation of the train is monitored from indication on the train operator's
console and each main running line is duly signaled for operation:
(iv) certain lines shall be equipped for automatic train operation with provision for the train
operator to assume manual control of the train if required;
(v) in the event of failure of the Automatic Train Operation equipment and on lines not so
equipped, train operators shall control their train up to the speed indicated on the
console;
(vi) where no cab indication is available, train shall be automatically restricted to a
maximum speed of twenty five kilometers per hour in "Restricted manual mode:
(vii) fixed signals are provided at the entrance and exit to each interlocked area and certain
other locations.
(4) (i) station Controller's control pa�el or work-station shall have the capability of setting
routes within the area of control, and of setting individual points when necessary;
(ii) on each platform, there shall be an emergency stop plunger and in the Station Control
Room, a switch for each platform which when operated shall cause any approaching
train to stop before it enters the platform. Any train entering or leaving or stationary in
the platform shall experience an irrevocable emergency brake aoplication.
(5) (i) The depot tracks may not be equipped with full complement of Automatic Train
Protection and trains shall be automatically restricted to a maximum speed of twenty
five kilometers per hour and the train operator may further restrict the speed of the train
in the depot lines to a lower value as provided in the special instructions
(ii) movements within depots shall be controlled by either main line type fixed Signals or
position light type;
(iii) control of movements within the depot shall be exercised by a Depot Controller from a
control panel or work-station located within the depot;
1152 Gll11-3
I,
,
;J THE GAZETTE OF !NDIA : EXTRAORDINARY [PART II-SEC. 3(i)]
'.he Depot Controller shall use a control panel or work-station for setting and clearing of
')Utes within the depot;
structions to train operators as to which siding they shall drive in or depart from may
·e given by train radio on a dedicated depot channel distinct from that used by
lperations Control Center;
the event of the failure of tt:e radio, a Public Address system may be used;
( 1• · nth a verbal instruction and a proceed indication from the fixed signals shall be
· :::eived before the train may move into the depot from the main line and vice versa.
(C (i) Local operation of poin,s o .. running lines as and when required may only be
,,ndertaken by a Station Cont.oiler with the permission of the traffic controller;
'.he crank handle used :c ma,·,:·:1llv operate the points is interlocked through a key
1hich, when released by Oper1tions Control Center controller or Station Controller,
hall inhibit setting of roui:c,s ,wf,r !he points concerned, and such transfer of control
· ,ould be acknowledgeJ by tne station controller before the local control can be
:tivated;
·,me points in depots are t•·a,!able, , 1 \lie event of a route failure they need not be
.meetly set before a movement is , uthorised over them in the trailing direction. Non
,ilable points shall be protern"d by fixed signals.
All lines of the network are Gquipped with Automatic Train Operations in which the
:icceleration, braking, observance of speed restrictions and observance of signal
.c,mmands are undertaken automatically;
• l the train operators shall close the train doors and start the train from a station and
,mitor its functioning;
:l all passenger trains sh8ii be equipped with Automatic Train Protection equipment
., ·,d can be driven manually under the control of the Automatic Train protection
,,tern;
, any over speed or fai!urc" k t,rcJke at the appropriate time results in an irrevocable
· . ,ergency brake appl,cal!c,;; whi0.:l: shall be referred to as " Coded Manual Mode";
, '- if Automatic Train Protect,c,n information is not available from the track side
:."!ipment, the train can t,.3 driven. with traffic controller's permission in "Run On Sight"
:, ::•de in which the on board Automatic Train Protection equipment restricts the speed
, 'he train to twenty-five kih1m,-te•, per hour and when the Automatic Train Protection
Thrmation is again avail8t 'e fro'11 the track, the mode automatically upgrades to
J,ded Manual;
· ·: if the Automatic Train ::Crote::tion is not available from the track or loco or cab side
· ;'iipment due to fault ::ir ::,•,,,,.,·,ic:s., the train may be driven with Traffic controller's
·· .. ·mission in 'Resirided M,.:1'•Ji' mode and in this mode tile on board Automatic Train
[ 'lT'T ll-191ls 3(i)) 19
========================·. , ,
Protection equipment restricts the speed of the train to twenty-five Kilo1r":te1 s per
hour, this mode shall be used in depots and exceptionally on running liw,s when
authorised by the Traffic Controller;
(vii) if the on-board Automatic Train Protection equipment is defective, thP tram may
be driven in "Cutout" mode as authorised by Traffic Controller and Nilen so
authorised , the Train Operator may open and operate a sealed switch an,:' drivP. the
train without Automatic Train Protecfr:in and in this mode, the Train Operate,, ,;;,a!I l11nit
the speed to twenty five Kilometers per r.our and be responsible fc• ,;"' s:?ife
movement of the train.
Previous and next
All provisions of Bangalore Metro Railway (General) Rules, 2011
Questions people ask
Is rule 20 of Bangalore Metro Railway (General) Rules, 2011 still in force?
No repeal of Bangalore Metro Railway (General) Rules, 2011 is recorded.