LawGrids logoLAWGRIDS.ORG

Rule 12, Tripura Factories Rules, 2007: Circular saws

Tripura Factories Rules, 2007 - Rule 12

Text of rule 12

Circular saws

12. Circular saws. – Every circular saw shall be fenced as follows : a) behind and in direct line with the saw there shall be riving knife, which shall have a smooth surface, shall be strong, rigid and easily adjustable, and shall also conform to the following conditions :- i) the edge of the knife nearer the saw shall form an arc of a circular having a radius not exceeding the radius of the largest saw used on the bench : ii) the knife shall be maintained as close as practicable to the saw, having regard to the nature of the work being done at the time, and at the level of the bench table the distance between the front edge of the knife and the teeth of the saw shall not exceed 12 millimeters : iii) for a saw of a diameter of less than 60 centimeters, the knife shall extend upwards from the bench table to within 25 millimeters of the top of the saw, and for a saw of a diameter 60 centimeters or over shall extend upwards from the bench table to a height of at least 23 centimeters : b) the top of the saw shall be covered by a strong and easily adjustable guard, with a flange at the side of the saw farthest from the fence. The guard shall be kept so adjusted that the said flange shall extend below the roots of the teeth of the saw. The guard shall extend from the top of the riving knife to a point as low as practicable at the cutting edge of the saw : and c) the part of the saw below the bench table shall be protected by two plates of metal or other suitable material, one on each side of the saw; such plates shall not be more than 15 centimeters apart, and shall extend from the axis of the saw outwards to a distance of not less than 5 centimeters beyond the teeth of the saw. Metal plates, if not beaded, shall be of a thickness of at least 2.5 millimeters, or, if beaded, be of a thickness of at least 1.25 millimeters. d) Hood or Crown Guard. – The crown of the saw shall be covered by an adjustable hood with an inverted ‘U’ or ‘L’ section of adequate strength. The material of the guard will not shatter if cutter is broken, be non- explosive and not more flammable than wood.

Previous and next

All provisions of Tripura Factories Rules, 2007

Questions people ask

Is rule 12 of Tripura Factories Rules, 2007 still in force?

No repeal of Tripura Factories Rules, 2007 is recorded.