Regulation 1296, REGULATIONS FOR THE AIR FORCE REPRINTED EDITION 2000: Aircraft-Flight Testing (a) An aircraft is to be flight tested in air during hours of day light by a competent pilot in the following cases before it is allowed for normal flying
REGULATIONS FOR THE AIR FORCE REPRINTED EDITION 2000 - Regulation 1296
Text of regulation 1296
Aircraft-Flight Testing (a) An aircraft is to be flight tested in air during hours of day light by a competent pilot in the following cases before it is allowed for normal flying
1296. Aircraft-Flight Testing
(a) An aircraft is to be flight tested in air during hours of day light by a competent pilot in the
following cases before it is allowed for normal flying.-
(i) After erection and major servicing/overhaul of the aircraft.
(ii) After any adjustment, repair or modification likely to affect the flying characteristics of
the aircraft.
(iii) After any work has been done arising from a report of a mechanical defect which might
have affected the safety of the aircraft.
(iv) After installation of aeroengine or automatic controls or after any of the major
components have been changed or adjusted which may affect the engine operation in the air.
(v) After a minor servicing on an aircraft or when specially called for in the servicing
schedule or required by any other instruction.
(vi) At the direction of squadron engineering officer/ chief technical officer.
(b) An aircraft which has been flight tested after overhaul or repairs and subsequently stored
unerected or without engines, need not be re-assembled for flight testing immediately after work
such as that referred in sub-para (a)(ii). After the re-erection and/or installation of the
aeroengine(s) the pilot making the test flight will be given information on any adjustment, repair
or modification likely to affect flying characteristics that have been made during the period of
storage and instructed to pay particular attention to the flying qualities of the aircraft with special
reference to the parts affected.
(c) After air test, test flight reports are to be raised in accordance with procedure specified in
Technical Staff Instructions.
CHAPTER XXIII-SERVICING, INSPECTION AND TESTING OF AIRCRAFT
Section 4-Testing of Aircraft and Engine
1297. Engines-Bench Testing and Ground Runs
(a) After complete, partial, top and hot end overhaul
(i) After complete overhaul or after partial overhaul in which major components such as main
bearings, gear box, turbine wheel, compressor assembly or other important parts (where the nature
of work carried out has been such that proof of satisfactory assembly and adjustment is necessary)
have been refitted or renewed, engines are to be subjected to bench test.
(ii) The tests will be carried out as per AP 1464C Vol I, Part I, Section I, Chapter 7 (for piston
engines) and Pt. II, See. II, Chapter 8 (for turbine engines) read in conjunction with relevant
Aeroengine AP Vol. VI, Pt. II or other current instructions.
(iii) After endurance test, aeroengines will be strip examinees in accordance with AP 1464, Vol.
II, Pt. I.
(b) After repairs
(i) Engines will be bench tested or ground run (if installed in aircraft) at the discretion of the
engineering officer directly.
(ii) The test after repairs should be dispensed with only when the repairs are obviously such that it
is impossible for them to have affected the running qualities of the engine.
1298. Blank.
1299. Blank.
1300. Blank.
Previous and next
← Regulation 1294Calibration and Adjustment of Compass installed in Aircraft. The compasses are to be calibrated and adjusted on the following occasionsRegulation 1301 →General (a) The object of the meteorological service of the air force is to provide necessary meteorological information to assist in
All provisions of REGULATIONS FOR THE AIR FORCE REPRINTED EDITION 2000
Questions people ask
Is regulation 1296 of REGULATIONS FOR THE AIR FORCE REPRINTED EDITION 2000 still in force?
No repeal of REGULATIONS FOR THE AIR FORCE REPRINTED EDITION 2000 is recorded.